How To Change Draw Length On Hoyt Zr200
Just to make certain we are talking about the same stuff here.
You are turning the weight locking screws first right? The ones on the side of the riser. There are four full, ii on the tiptop limb pocket and two on the bottom. Unless you have an older Hoyt hunting bow with only i side weight locking screws. They are the same size allen wrench that the limb bolts are.
I fear yous may have loosened the pivot signal screws. They are at the back of the riser and connect the pocket to the riser. They utilise a smaller size allen head, and are continued. They have to exist torqued to a certain weight and should NOT be played with. If you retrieve you undid those, bring information technology to a shop as they will know what to torque information technology back upwardly to. DONT shoot information technology without them being checked offset though, equally y'all could do serious damage. Hopefully you didnt strip them, (unfortunately its not hard to do).
Subsequently you accept loosened the weight locking screws, you may turn the limb bolt counter clockwise to lower the poundage. v turns should equal almost a 10 pound drop in draw weight, merely not every bow setup is the same so check it with a bow-scale. Also, brand sure to turn the limb bolts equally, superlative and bottom. Equally this volition keep your tiller the same.
To be perfectly honest, you can change the draw weight without loosening the weight lock screws, it will be harder to do, just Ive been a dunder head and forgotten to undo them in one case or twice and they honestly dont practice all that much. I think if Hoyt "ridged" them, it would serve a much better purpose.
My bet is that you undid the pocket to riser connectedness and that you need to get information technology torqued support at the shop. If you lot are still unclear on what screws are what, have them go over it with you.
Proficient luck, hope all is well with the bow.---Matt
Source: https://www.huntingnet.com/forum/technical/101787-adjusting-draw-weight-hoyt-bow.html
Posted by: charltonthishatthe.blogspot.com
0 Response to "How To Change Draw Length On Hoyt Zr200"
Post a Comment